给袋式包装机进入我国已有数年的时间了,经过这些年的发展和追赶,虽然与国外同类产品仍旧有着不小的差距,但是已经完全能较好地满足我国包装产业的需求。

It has been several years since the bag packing machine entered our country. After years of development and catching up, although there is still a big gap with foreign similar products, it can fully meet the needs of our packaging industry.

1.气路需提前准备能够满足计量机1立方米、储气罐1立方米以及冷干机1立方米的空气压缩机，以保证设备的正常运行。

1. The air compressor that can meet the requirements of 1 cubic meter of metering machine, 1 cubic meter of gas storage tank and 1 cubic meter of cold dryer should be prepared in advance to ensure the normal operation of the equipment.

2.电路方面根据电压和额定功率要求准备插排和相应的三相五线电源，用于安装使用喷码机、计量称重机以及启动给袋式真空包装机；

2. In terms of circuit, according to the requirements of voltage and rated power, the plug-in and corresponding three-phase five wire power supply are prepared for the installation and use of inkjet printer, weighing machine and start-up of bag vacuum packaging machine;

3.对于包装酱腌菜类的产品的设备而言，其产品含盐量高，腐蚀型强，用清水冲洗不仅可以满足食品卫生要求，也可以降低酸碱盐成分对设备的损伤。

3. For the equipment of packing pickle products, the product has high salt content and strong corrosion. Washing with water can not only meet the requirements of food hygiene, but also reduce the damage of acid, alkali and salt components to the equipment.

4.给袋式真空包装机开机核对显示屏数据，根据数值对设备的电、气路进行检测，压缩空气气压是否达到要求，先运转2个工位，观察机械有无碰击异响。

4. Start the bag type vacuum packaging machine, check the display data, test the electric and gas circuits of the equipment according to the value, and check whether the compressed air pressure meets the requirements. First run two stations to observe whether the machine has bumping and abnormal noise.

5.打开电源开关，接通电源，预制袋就位，设定和检查设备的温控仪和调整主机运转速度，先不进行上料，空转 看空包装袋的封口效果，如果封口效果平整无褶皱，再加。

5. Turn on the power switch, turn on the power supply, put the prefabricated bag in place, set and check the temperature controller of the equipment and adjust the running speed of the host machine. First, do not load the material, idling to see the sealing effect of the empty packaging bag. If the sealing effect is flat and without wrinkles, add.

6.在包装过程中，质检人员应随时对包装好的产品，进行抽查，看真空袋的封口是否完好，如果出现褶皱或者密封不好的现象，对设备进行及时调整，避免出现大批量的不合格品。

6. In the packaging process, the quality inspection personnel should check the packaged products at any time to see whether the sealing of the vacuum bag is intact. If there are wrinkles or poor sealing, the equipment should be adjusted in time to avoid large quantities of unqualified products.